- This topic has 2 replies, 3 voices, and was last updated 2 years ago by
.
Stannah 420 Installation manual and query
-
-
Hi All!
I came into posession of a Stannah 420 for my wife, but I could do with setup instructions for it if someone has an electronic version available please? A schematic would be handy too.
This lift has the hinged lower section, my query is can I set it up such that the chair will charge whilst at the bottom? The hinge is not required for my application and can be bolted closed. The rail currently has 3 busbars of which the middle one stops short. I assume that is the charging bar as I was told it will only charge in the mid to top section.
-
Hi Colin
I acquired a Stannah 420 and I am looking for installation manual or an independent fitter in the Farnham, Surry area to install it.
Have you had any luck with your search for information?
Regards
Simon
-
yes its possible to set it to charge on the hinge section, would need to lock off the hinge with the transit plate two 13mm bolts under the rail, loosen them, slide the plate down and tighten them up, so it cant lift! then replace the central copper strip so that it runs the full length of the rail, the charge strip, then disconnect the hinge motor, thats the easiest way to do it! otherwise its a carriage cover off job and reverting it all back to a non hinge lift
-
You must be logged in to reply to this topic.
