Stairlift Forum

Compact AC question

P

Pie · 25 Mar 2022

I went to put a Bison Compact AC back into service yesterday, it was working before being un-used for a year or two.

After powering on, the display went to S for a few seconds then changed to P. The resistor near the top of the board was getting very hot discolouring the board.

I checked all the usual places for worn wires/shorts and everything seemed in order, all looks in good nick.

The hinge works fine and if you put a call in before powering on, the chair runs up and down normally - until you stop when the P appears.

Any ideas?

I don't have a spare board and cannot find one - even on e-bay. I can get this one repaired but don't want to go to the trouble and expense to find it wasn't the board.


K

kevin · 25 Mar 2022

Yes power frame fault, either continue putting the call in before turning on or try and locate a replacement pcb.

T

TheStairliftGuy · 14 Apr 2022

The PCB can be repaired, cant remember for sure but seem to remember this being a MOSFET fault.

Know the answer, or have the same problem?

Related discussions