-
Meditek Service Reset
MediTek D160
From day 1 the stairlift has been serviced annually, only on the last occasion did an engineer mention “there’s hardly any need, it’s like new!”, yet for 4 yrs they’d been taking the service fee.
Enough of that!
Although it only gets minimal use eventually the “Service Due” message has appeared.
Through trial & error, hopefully not too much error, I managed to locate a procedure to reset the message, via the push buttons on the circuit board.
<font face=”inherit”>It </font>again<font face=”inherit”> says “Lift Ready”.</font>
<font face=”inherit”>
</font><font face=”inherit”>Now the questions: “Trips” showed as 2430 before reset, with “Service” showing as 0000.</font>
<font face=”inherit”>After button presses “service”” showed 6000.</font>
<font face=”inherit”>Does this mean the “service due” will reappear in another 3570 trips?</font>
What’s the best method to reset things to norm?
<font face=”inherit”>I should also mention that while the cover was off, </font>electrical<font face=”inherit”> connections </font>were<font face=”inherit”> all checked for tightness, nothing was mechanically </font>obviously<font face=”inherit”> out of place & the </font>area<font face=”inherit”> was given a wipe clean. Basically everything the company had been </font>changing<font face=”inherit”> a small fortune for.</font>
Thanks<font face=”inherit” style=”font-family: inherit; font-size: inherit;”> in advance.</font>
Log in to reply.