Stairlift Forum

Minivator 950 Limit overuns - now and then!

W

whatgoesup-mightcomedown · 01 Jan 2016

Hello all - new to forum, although have been installing various lifts for a good few years. Having a bit of an issue/niggle, with this lift(Min 950) - circa 2008 ish. The problem is an irregular overun - in this case at the top. Limit switch first port of call - in this case great condition. Sometimes a full run lift does as it should - then for no apparent reason - overruns onto final limit. Any ideas - maybe fault on PCB? or suspect Brake?. Both types of limit sliders tried . Only overunns at top with person onboard . Welcome fellow engineers thoughts (limit circuit verified) DIP settings default positions etc.. :confused::confused:
K

kevin · 01 Jan 2016

I would suspect play in a roller.
W

whatgoesup-mightcomedown · 01 Jan 2016

Thanks for that - Kevin, can see your logic, design of lift by definition already means plenty of forward play, I suppose only made worse with play on worn rollers - lifting the limit switch off enough to travel to final limit, will check it out, cheers, Anthony
N

northern-mobility · 04 Jan 2016

More likely to be the limit stop, put the new plastic one's in and pack out the back of it (where the cut out is) with a bit of folded card to stop the play in it. I have had countless similar problems with the 950, usually at the bottom but this is the first thing to try

Know the answer, or have the same problem?

Related discussions