Stairlift Forum

Stannah 260 Info

G

g-man · 15 Jun 2017

just wondering if anyone can give some info or meaning to the stannah 260 main pcb led 1 Fail red will activate under following conditions

1. relay 3 K3 contact weld

2. relay 1 and 2 K1, K2 contact weld

3. direction input short cicuit on control pcb (not wiring loom)

4. q1 failure

5. q2 failure

6. motor disconnected

unsure of meaning for 3, 4 ,5 or what is causing this, cheers Gordon

R

robbrownstairlift · 16 Jun 2017

As stated relay contacts have failed, if displayed on initial power up of board check battery voltage before replacing/repairing board.
I

ianb · 16 Jun 2017

Can also be caused by high resistance on a limit switch or bad battery connection. It can also be a motor gearbox failure as well. What type of seat does it have?. If its a sarum with a power swivel the change over microswitch No/Nc black one in the swivel can go high resistance and cause an led 1 fault. On sienna or starla seats a swivel micro switch can cause an led1 fault. If its the later 2 then it would only go led1 on one direction sarum example would only happen on a down call. Starla and sienna could be up or down depending on what swivel switch was playing up. If its a motor fault you can normally tell by giving it a hand wind same time as putting a call in. \If it starts up then its the motor. I have had led 1 faults occur on all of the above examples more than I have had pcb fails. (12 years a stannah engineer). Hope this helps. ;)
G

g-man · 19 Jun 2017

thanks Ianb for the info had this fault on various Stannah sarum and sienna seats works answers is new pack and seat I knew what 1,2,6 where just didn't know the reason behind the other ones cheers

Know the answer, or have the same problem?

Related discussions