MemberMarch 28, 2021 at 4:46 pm
Thanks Kevin for your quick reply,
You are absolutely correct, the pickup was stuck in. I pushed on the nut and it popped back, the limit switch reset and the chair now powers up and complains it’s not charging as it’s off the charging ramp. I have it on a lab power supply, so I haven’t run the chair.
I took the pickup out and the shaft is bent as the photo shows. I can probably straighten it, but the plastic sleeve looks to have taken the impact as well, and that’s harder to fix to be sure it slides easily. I will see if I can get replacements. Once it’s up and running I will check very carefully that the limit switches trigger in the right sequence. Everything was on the chair so it should have worked correctly.
Thanks again, I’ll post back here as I progress.