Reply To: Error Flow2a

[Laurent]

April 18, 2021 at 3:17 pm

Thank you so much for your help.
I was able to cancel the F53 code. It was in SA but it must have had a validation problem.
I was able to reprogram my rail with the SD card.
This works well with RF remote controls but not with the UI user interface (cabled model).
It lights up red and nothing happens.
I recorded it in mode 7 as the RF remotes but I have nothing defin in mode 8 for the UI.
In mode several symbols are unknown to me: Err, Cer, Fsd, Bra Up9 and Anr.
Thanks again.

Laurent