Stairlift Forum

260 Starla Seat Swivel pcb error

K

kevin · 20 Sep 2021

I've got a fun one. 260 with starla 2 way powered swivel.

The lift stops intermittently at the same spot halfway up the rail and gives an error on the swivel PCB led 1 - board fault.

Won't reset on the pcb, no obvious shorts to ground on any of the wiring

Wind it down and off it goes again, for a few days.

I'm thinking wiring short tripping the pcb out rather than the pcb being the error.

I plan to swap out the swivel pcb and trunion looms unless anyone has any suggestions.

C

clive · 20 Sep 2021

Bet you’ll find a break in either the skate or cluster loom, my money is in the cluster loom, esp if stopping in same place every time…. .a way to diagnose the fault, ( and this is only to assist diagnosis, dont leave like this) is to remove the p clip that holds the loom on and by allowing the cable to move more freely then the fault may disappear briefly……….

Know the answer, or have the same problem?

Related discussions